Install the left-hand coolant hose bracket. Install both front drive halfshafts. Bend back the locking tab. Install the engine front mounting bracket. Tighten the wheel nuts in a diagonally opposed pattern. Install the upper heat shield. Fit the cylinder head cover.
Pull it out of the air cleaner housing push fit. Remove the boot outer retaining clips. For additional information, refer to Oil Pan in this section. Fit the tripod star assembly. Tighten the bolts of the camshaft timing pulley. Install the exhaust manifold with a new gasket. Install the parking brake control cover trim.
Fit the cylinder head cover. Push in the locking handle. Base exposed - poor lubrication. Install the timing chain onto the camshaft sprocket. Detach the lower arm ball joint. From inside the passenger compartment, disconnect the flexible coupling. For additional information, refer to Section 308-06.
Install the power steering pump. Rotate each tie rod equally clockwise or counterclockwise to adjust the toe setting. Using the special tool, remove the valve seals. Using a suitable Transmission jack support the crossmember. Attach the crankcase ventilation hose.
Secure the accessory drive belt lower guard. Remove the blanking cap from the power steering fluid cooler return line and connect the line from the power steering gear. Tighten the clamp bolt of the timing belt tensioner. Install the lower arm to the wheel knuckle. Detach the shift rod and gearshift stabilizer and tie up.
Refer to Section 204-02-17 7. Keep all parts in order for reassembly. Remove the hub cap if fitted. For additional information, refer to Specification. Raise and support the vehicle. Fluoroelastomer Diesel engine See Viton. Install the auxiliary drive belt.
Remove the lower air deflector four screws. Loosen the axle stub nut. Lubricate the main bearing journals and bearing shells with engine oil. For additional information, refer to Section 308-00. Install the coolant flow control housing. Install the camshaft bearing caps. Remove the engine front mounting bracket.
Attach the coolant hoses to the thermostat housing. Disconnect the spark plug wires from the spark plugs. Disconnect the cable from the secondary brake shoe. Remove the leaf spring from the vehicle. Connect the power steering fluid cooler line to the power steering gear support bracket. Remove and discard the rear oil seal retainer.