Its higher mass also reduces acoustical interference. I could not slide the cartridge far enough out in the screw slots to get the right overhang. Reproduction without prior permission or for financial gain is strictly prohibited. Another harder point of dissasembly is the slotted end screw that holds the arm on. I purchased this turntable new in 1985 and have used it as my only analog source for 17 years.
They don't make these any more, so it makes sense to try and find one that someone didn't use that much. The autolift can be easily turned on and off. Not even three threads could even be screwed into the motor holes. For the audiophile wannabe on a budget these are perfect. Description A more massive platter and a larger, more massive base distinguish the Harman Kardon T40 from the T20. Before this I had a Thorens and this is superior in many ways. The platter and arm board assembly is supported by three fully adjustable springs.
This allows you to use a good quality interconnect of your choice. When set up with the right cartridge I have been absoultely thrilled with this component. You will not be disappointed. The effective tonearm length, stylus overhang and offset angle have been precisely determined to provide the lowest possible harmonic distortion over the total playing area. I actually own the T65C, but no review category existed for that model so I used the T60 category.
It has a heavy record clamp, auto lift off, adjustable cartridge loading, adjustable speed and phono jacks on the back instead of the more common fixed cable. It has served me faithfully for 15 years and I wouldn't hesitate to recommend it to anyone if you can find one. The base is 30mm thick and composed of high density particle board. The T65C simply sounds good, neutral, and airy. .
The tonearm by Ito is low mass and carbon fiber. This results in a construction that is both rigid and vibration absorbent. One thing to note is that if you decide to take off the motor from the mounts, I found that the screws were way too short. The problem is that once you have gotten your nifty new product, the harman kardon t35 auto lift turntable service manuals gets a brief glance, maybe a once over, but it often tends to get discarded or lost with the original packaging. Removable headshell allows for easy exchange of cartridges.
An optically sensed auto-lift tonearm is incorporated, eliminating the return mechanism entirely and further minimizing unwanted tonearm vibration. The difference being the adjustable, string weighted antiskate on the 65C. Reproduction without prior permission or for financial gain is strictly prohibited. I found I could drop the noise floor even further by covering the platter in sorbothane covered with a cork mat and by filling the inner portion of the underside of the metal platter with spray foam insulation. Large, high compliance springs and foam damping material in each of the four feet effectively isolate the base from mechanical vibration and shock.
Unless you have the right tool do not attempt to remove the nut. My Ortofon installs fine with this arm but I could not get the right setup with the Shure. The high-loss vibration absorbent platter mat, made of a special high-density rubber, helps prevent vibration from travelling from platter to disc. These are really nice looking turntables. Register a Free 1 month Trial Account. It arrived with the platter in place and a ruined main bearing that wobbled in the main bearing plate. Speed is adjustable or you can use the fixed setting.
No mechanical linkage, springs or gears to muddy the sound. I have owned this turntable for many years and have been very happy with it. A disc stabilizer damps vibration and improves accuracy by reducing record movement. I have a model 60C and 65C. Hands down better than anything I have use previously. A fine piece of work.