Yamaha fz6 2007 all versions service manual. FZ6 (2007) Full Workshop Service Manual (Yes. Free 2019-02-16

Yamaha fz6 2007 all versions service manual Rating: 8,3/10 1750 reviews

Yamaha FZ6

yamaha fz6 2007 all versions service manual

Route the crankshaft position sensor lead above the starter motor leads. Right handlebar switch lead 7. Either installation position can be accepted, but make sure that the leads are not crossed. Pass the hose and lead through the clamp and insert the clamp into the bracket. Good luck and have a nice day.

Next

Reading : 2007 Yamaha Fz6 All Versions Workshop Repair Manual

yamaha fz6 2007 all versions service manual

If this occurs, have a Yamaha dealer check the electrical cir- cuit. Front cowling inner panel 3. As a quick remedy, use a contact revitalizer available at most part stores. Connect the lead to the meter. The limit of this brake force is determined by the friction force between the tire and the road surface and is closely related to wheel slippage. Stand the vehicle on a level surface.

Next

Yamaha FZ6 2007 All Workshop Service Repair Manual

yamaha fz6 2007 all versions service manual

Route the crankshaft position sensor lead inner side of the radiator hose. Hook the clamp to the bracket. Pull down the mark-painted sections of the fuel tank breather hose and fuel tank drain hose to be lower than the clamp position of the muffler stay. Stand the vehicle on a level surface. Route the main switch and immobilizer lead inside in the width direction of the vehicle of the left handlebar switch lead.

Next

Reading : 2007 Yamaha Fz6 All Versions Workshop Repair Manual

yamaha fz6 2007 all versions service manual

Pass the right handlebar switch lead through the hole located on the right side of the frame. Operating the engine without the air filter element will also affect throttle bodies synchronization, leading to poor engine performance and possible overheating. Any order to take out the fuel tank breather hose and fuel tank drain hose can be accepted. Cylinder 2 injector coupler Disconnect. Route the right handlebar switch lead under the bracket 2. Use oil and grease recommended by Yamaha for all lubrication jobs. Check: Brake fluid level Below the minimum level mark b Add the recommended brake fluid to the proper level.

Next

Popular Yamaha FZ6 Repair Questions, Solutions and Tips

yamaha fz6 2007 all versions service manual

Front wheel sensor coupler 6. Throttle cable return side 23. However, if dis-tilled water is not available, soft water may be used. Below the minimum level mark Add the recommended coolant to the proper level. Place the neutral switch lead coupler under other leads so that it is not seen through the frame open-ings. The clamp is attached from the bottom after the work of 1.

Next

Yamaha Fazer FZ6 S2 2007 Service Manual ENG

yamaha fz6 2007 all versions service manual

Hydraulic brake service Regularly check and, if necessary, correct the brake fluid level. Replace: Rear wheel sprocket a. Good luck and have a wonderful day. Check: Engine idling speed Out of specification Adjust. Check each bulb and bulb socket for damage 1. Turn the adjusting nut 3 in direction a or b to take up any slack on the decelerator cable.

Next

Popular Yamaha FZ6 Repair Questions, Solutions and Tips

yamaha fz6 2007 all versions service manual

Modifications and significant changes in specifications or procedures will be forwarded to all authorized Y amaha deal- ers and will appear in future editions of this manual where applicable. Adjust: Clutch cable free play Handlebar sidea. Measure the deflection 23 mm 0. Either installation position can be accepted, but make sure that the leads are not crossed. Turn the idle adjusting screw 1 in direction a or b until the specified engine idling speed is obtained.

Next

2007 2009 yamaha fz

yamaha fz6 2007 all versions service manual

Point the opening section of the clamp upward. Clamp the starter motor lead and crank- shaft position sensor lead. If the front wheel does not remain station-ary at all of the positions, rebalance it. To the rear brake caliper8. To the oil level switchL.

Next

FZ6 (2007) Full Workshop Service Manual (Yes. Free

yamaha fz6 2007 all versions service manual

Measure: Brake disc thicknessMeasure the brake disc thickness at a few different locations. Useful terms Wheel speed: The rotation speed of the front and rear wheels. Right side 1, 2 and 3B. To the headlight and meterG. Route the crankshaft position sensor lead above the starter motor leads. Before the vehicle is operated, the air must be removed by bleeding the brake system. Therefore, anyo ne who uses this book to perform maintenance and repairs on Y amaha vehicles should have a basic understanding of mechanics and the techniques to repair these types of vehicles.

Next